Cnc Squirt

Need Help! V-CNC 500 lube pump (priming?)

The functional pump out the oil that was still in it, while the other did not anything. So it appears it was dry. Inlets

The 3018 “pro” can ABSOLUTELY cut aluminum! The 3d printed part

version. Naysayers can nay say. No mods here other than using a of WD-40 every pass.

Double stick tape to hold part?

Consequently, we've been known to take a little coolant from the and it on a stubborn sticker to remove it. Works scary good, and

[CNC] Ball screw lube?

Do ball screws need lube? My machine runs dry (no coolant or misting) and I only cut plastics. Shall I run them dry or give them of

Repository for Config's and Macro's | Duet3D Forum

specific configs and custom macros from all the experienced Duet users. = null;. } /** Strip the

Kinktober Day 2: | Alpha!Bucky x Omega!reader

Today is all about Assume it'll all be nsfw! The first time it happened, you had no idea what was going on. You thought for sure

Machining | Brother tool stuck | Page 2 | Practical Machinist

Given how bad the crash was I wouldn't hesitate to give that busted stud some smacks with a long rod and a few of wd40.. Ya got

Stepper vs. Brushed DC for fast rig - Motors, Mechanics, Power and

Most of the machines are either lathes or They just need to know "we are now passing point 237564, give a little of blue".

OMIO Tips, Tricks and Questions - #442 by Zatack7

Blowing the chips clear of cut? I general shoot for .002ish in/Rev and 2mm DOC. Somewhat faster for poly. Lots of air. Occasional of wd-

DIspense very accurate micro volumes - Motors, Mechanics, Power

= 6.68 uL. I think I have that right? If so - then if you got Motors, Mechanics, Power and 6, 1966, May 6, 2021. Any ideas