Thick Stripping

Weather too | ClassicBroncos.com Forum

Don't change your body lines to make the gaskets fit. If you have good gaps, leave them and hope the new gaskets form in a couple of weeks. You 

shellac from birch conference table : r

Spray however much you like within a reasonable area. Cover it fairly quickly so that the alcohol and the fumes can do its job. Wait 5 minutes 

CloudBuyer Foam Weather Rolls, 1 Inch Wide X 3/4 Inch

CloudBuyer Foam Weather Rolls, 1 Inch Wide X 3/4 Inch Insulation Foam Strips with Adhesive for Door,Automotive,Air Conditioner Seal, 

damaged nonstick coating from old aluminum pot and

Although, not a DIY project. It is entirely possible to have a pot recoated. Just google pot recoating in your area and you should get an answer 

Knife for larger multi-conductor cable? | Information by

Yesterday as I was standing in the cold and wind some 2/0 multi-conductor cable with a jacket (on the cable, not my self) while being very.

a guitar. clear factory seal coat under the paint is hard

use largest grit possible (40-80) to break the shiny surface layer, then move one step higher for removal. Use a ceramic or zirconium abrasive.

Isopropyl alcohol on really paint: will it work for

Isopropynol leaves behind no residue and evaporates at room temperature. Soak them over night in 99%, light scrubbing the next day should remove 

Large Type TC Cable | Information by Electrical

hard casing on them.they are very robust in nature. It is easy to strip the versions smaller than 500 kcmil with a knife, hooked 

Black Felt Adhesive Backed 2" Wide x .5mm (.02”)

Black Felt Adhesive Backed 2" Wide x .5mm (.02”) 50' Roll - 2 Roll Minimum Bulk discount rates.

Meta Aramid (Nomex) - 2" Wide x 1/8" – thefeltstore

Meta Aramid (Nomex) - 2" Wide x 1/8" Nomex® (also called meta-aramid felt) is a high-temperature felt that protects against extreme heat.